Connected W10 successfully. CM reports connect at bottom right of CM. COMM3 is selected. It is the only selection. Find button still can't find the connection.
From: MAIN@ESPMC-Eight.groups.io <MAIN@ESPMC-Eight.groups.io> on behalf of Wes Mcdonald via groups.io <wesmcd6@...>
Sent: Monday, December 7, 2020 12:48 PM
To: MAIN@espmc-eight.groups.io <MAIN@espmc-eight.groups.io>
Subject: Re: [ESPMC-Eight] Newb issues after firmware, ExploreStars Data Base update #iEXOS-100 #Android
Windows 10 will connect ok to the iexos 100 adhoc it seems. Has issues with the exos2 tho.
So make sure tablet WiFi is off. Disconnect iexos from pc. Reboot iexos. When it boots join the network. Cm should show green pmc8 connection on bottom. On cm connection tab set mount type and set comm port to comm3. If comm3 is. It visible press refresh and the. Select comm 3. Then try find button.
If it cannot find the mount go to the advanced tab. Set the radio button to tcp. Send ESGv command with button see do you get a response. If not light up the udp radio button and try again.
Assuming you get an ESGv reply on tcp you can then send an esx! Command via tcp that will reboot the iexos in udp mode
If neither connect, try using the serial button and ESGv. If that works then send the esx via serial
Try this and get Back to me
On Mon, Dec 7, 2020 at 1:41 PM Joe Izen <joe@...> wrote:
Wes, Southport NC
EXos2-GT PMC-8, iExos 100
ES ED 127, 10" LX200GPS+wedge, Astro-Tech 8" Newt, ETX-90, 60mm no-name guide scope ~ 260mm FL
Polemaster, Orion ST-80 and SAG, ZWO 290MM, D5300 astro modified
Nina, Bootcamped Mac Mini control computer, RDP to iMAC
110 amp hour lead acid deep discharge battery for field power
Electrical Engineer, Retired