Re: iEXOS 100 - lost communication #iEXOS-100 #ExploreStars #ConfigManager


Wes Mcdonald
 

Jlospinuso:

What is your name
What is your quest 
What is the capitol of Afghanistan 

Get your serial cable, make sure it is not power only

Load the parallax ftdi driver from the parallax web pag

Plug everything in.  Boot iexos.  Connect WiFi to pmc8 network 

Open configuration manager. 

Check the cm shows green lower right on connection tabfor the WiFi 

Press the refresh button
Drop down comm port list and select the pmc8 comm port

Press find button

If you get a positive response press top right do it button

Then set the comms mode to udp

Good luck

Hopefully you will avoid the valley if eternal peril





--
Wes, Southport NC
EXos2-GT PMC-8, iExos 100
ES ED 127, 10" LX200GPS+wedge, Astro-Tech 8" Newt, ETX-90, 60mm no-name guide scope ~ 260mm FL
Polemaster, Orion ST-80 and SAG, ZWO 290MM, D5300 astro modified
Nina, Bootcamped Mac Mini control computer, RDP to iMAC
110 amp hour lead acid deep discharge battery for field power
Electrical Engineer, Retired

Join MAIN@ESPMC-Eight.groups.io to automatically receive all group messages.