Oops. Missed that detail. Nice catch Jerry Wes

#iEXOS-100

Vijay I believe this is a common condition with the asi air. The solution is to load the “a” version of the firmware into the pmc8. That version tracks continuously without being continuously pinged.

#iEXOS-100

Nice work. You are off and running! Wes

#G11 #astrophotography #iEXOS-100 #EXOS2

Adam Ugh For a camera only rig I guess I would find me a hot shoe adapter. If we target a red dot with a synta mount then you could use this: https://optcorp.com/products/idea-dovetail-bracket-for-dsl

#polaralignment #iEXOS-100

Adam. Ok iexos 100. Sorry The peep hole is fine but it will be a poor polar aligner. You may as well just center Polaris in the tunnel. That is fine enough for visual work IF you have a wide field fin

#polaralignment #iEXOS-100

To get collimated get the dead center of the polar scope on the dead center of the ra axis. You have to do this by rotating the ra axis and adjusting so that the dead center of the polar scope never d

#polaralignment #iEXOS-100

Wade I would clean out the metal and see if it comes back. Your imaging setup has some interesting limitations. Your image looks danged good to me Your imaging resolution is about 3.7”. This is based

#iEXOS-100

Guys you can get the exact version back by using the configuration manager and sending the ESGv! Command. It will return the full version number which you can bounce off of the version number you thou

#ExploreScientific #FIRMWARE

The 100 has the same motors as does the exos2. The torque is the same. It’s ability to handle of balance loads is probably the same. If anything it will be better at it if the scopes are smaller. Star

#iEXOS-100

Yorksman There is video from ES that shows how to adjust the mesh for the iexos. https://m.youtube.com/watch?v=mLXE_BMKVAw&t=39s This will show you how. Also in the files section of the mounts subgrou

#iEXOS-100

You are binding. Make sure the balance is good. Might need to adjust your worm/wheel mesh Wes

#iEXOS-100

Richard: Use the Configuration manager to upgrade the firmware. It knows where all the latest firmware is, brings it in, lets you select the version you want, and loads it all through an easy UI. Wes.

#EXOS2 #pmc-eight

Yes indeed. And once in serial the pmc8 will remain there until you change it We’d

Peter: No I dont think it is faulty, at least not yet. 1. You must have your PC attached to the PMC8 via wifi for the CM to function correctly. 2. Get a clean boot of the PMC8 and choose the PMC8 wifi

Peter Give us a rundown on your configuration, cables etc etc. One item that bit someone with the iexos was the usb cable they were using was a charging only cable with no data wires. Make sure you ha

👍

#G11 #astrophotography #iEXOS-100 #EXOS2

Dave what focal length are you at?

#G11 #astrophotography #iEXOS-100 #EXOS2

Dave what is the guide rate u have set in the driver?

#G11 #astrophotography #iEXOS-100 #EXOS2

Ron: Glad to have you aboard! The apps and the firmware are not coupled so as to mess one up if you previously used the other. The only caveat is you have to get the mount into certain communication m

Jennifer: WOWOWOW!!! Fantastic wes.

#G11