Folks: Been discussing things with Jerry relative to topics related to using the PMC8 with applications and or hardware from other than Explore Scientific. Jerry is going to create a new subgroup, cal

Guys The movement of the steppers is not perceivable in images. The steps are way to small to be discerned by your camera. Just so you know when you are actively guiding, where the motor rate is alter

#iEXOS-100

Relative to hissing sound. Folks the pmc8 drives the motors 100% of the time, even when the mount is sitting still. Wait, what? Yep. The motors are stepper motors and are always energized. The current

#iEXOS-100

John That last point of Bob’s is important. That screw head can interfere with your motor when you go to position it. The motor ends up rocking on the head of the screw and that prevents you from gett

Michael Delicious. I’ll have two please. Wes

#G11 #astrophotography #iEXOS-100 #EXOS2

Wade We love us some andromeda! Looks good Wes

#G11 #astrophotography #iEXOS-100 #EXOS2

jeff Looks like crap on the sensor. Looks like it was left over from cleaning. I have that stuff all over mine. Tried to clean it and that didn't work. Got to try again...then send it off to someone w

#G11 #astrophotography #iEXOS-100 #EXOS2

Jeff So nice. So nice.

#G11 #astrophotography #iEXOS-100 #EXOS2

Stade: A great start! Wes.

#G11 #astrophotography #iEXOS-100 #EXOS2

Marko Yes please keep it up. I feel we into what is happening here. This will help others if we can nail down the steps to get recalcitrant PCs working. So far we know to: 1. Check via ipconfig if the

So the driver has bugs. Get a new one https://windowsreport.com/intel-wifi-driver-update/ Wes

Marko Go back into your network settings per Doug. Uncheck v6. Leave only v4 checked That network card is not recognizing v4 it seems. There might be information out there for a new driver for that ca

Marko Please use your neighbors laptop and after connection to the pmc8 network take a look at ipconfig. In your pc disconnect all WiFi networks and make sure none are selected to connect automaticall

Jeff Yes it looks like that is what he did. Explains 0ms rtt Wes

Henry Press the connect button on the hub. Wes

Peter I presume this is in a non working WiFi connection? Notice the ip address is not the one you should have. This pc is not connected to the pmc8. It should be 192.168.47.11. My other email had yet

Yes Jeff. Ipconfig. Typo on my part. Nice catch.

Far as I can tell the omc8 exos2 module only connects via 2.4 ghz. That is WiFi channels only 1-11. V6 is independent of WiFi etc I believe. It is an IP thing. A WiFi router may or may not support IPv

Marko I don’t think you or should have an IPv6 address when connected to the pmc8. This is what is likely going on. I have to research this some. Something is amiss here. Peter, once you switched to s

Peter: Sooo you changed your computer also when you loaded the new version of firmware? HaHa. The thing to remember is always that the PMC8 is the last place to suspect. Compared to every other comput